Lexmark T65x and X65x Mono Product Study Guide Rev 1.47
For Training Purposes Only 6/3/2009
17
Document Scanning
Document scanning at ADF
The document scanning section of this machine consists of a scanner that reads a single-sheet document
placed on the platen glass and a document feeder that can transport a multiple-sheet document for one
or two sided scanning.
Document scanning at platen
Shown below is the operational overview of document scanning at the platen.
The scanner CCD assembly travels to read the document.
The exposure lamp is installed on the scanner CCD assembly. As the scanner CCD assembly travels, the
document on the platen glass is scanned and exposed with the exposure lamp.
The image data is read with the scanner CCD image sensor assembly.
This ADF employs a constant velocity transport system that scans images by feeding the document at a
constant speed over the specified position (scan position) where the carriage of the scanner unit
assembly is fixed.
Names and functions of components
The sections below describe the functions of main components of the scanner.
Flatbed (FB) Scanner unit assembly – [APS; automatic paper sensor]
Sensor (FB length APS 1), Sensor (FB length APS 2), Sensor (FB length APS 3)
The document length in the slow scanning direction is detected by a combination of the three
reflector sensors.
Switch (ADF closed interlock)
A switch that detects whether the ADF is open and determines the timing of platen document size
detection.
Scanner drive motor assembly
A stepping motor that drives the scanner CCD assembly.
To Next Page
Loading...
Need help?
General
