Loading paper and specialty media
This section shows how to load the multipurpose feeder (Tray 1), the 250-sheet tray (Tray 2), and the optional 550-
sheet tray (Tray 3).
Loading Tray 1 (MPT)
In addition to plain paper, Tray 1 (MPT) can use various other sizes and types of paper or specialty media, such as
envelopes and transparencies.
Notes:
• Make sure Tray 2 is completely installed before opening Tray 1 (MPT).
• Load up to 150 sheets or a stack of paper that weighs 60–216 g/m
2
and is less than 15 mm (.59 in.) high. The
minimum paper size supported is 76.2 x 127 mm (3 x 5 in.).
• Tray 1 (MPT) supports paper or specialty media within the following dimensions: 76.2 x 127 mm–220.0 x 355.6 mm
(3 x 5 in.–.8.66 x 14 in.).
• For duplex printing, you can load paper that is 64–163 g/m
2
.
• Do not load different types of paper at the same time.
• Do not remove or add paper to Tray 1 (MPT) when printing, or if there is any paper still in the tray. Doing so may
cause a paper jam.
• Do not put any objects other than paper in Tray 1 (MPT).
• Always load paper short edge first.
To load paper in Tray 1 (MPT):
1 Gently pull open the Tray 1 (MPT) cover.
Loading paper and specialty media
42
To Next Page
Loading...
