From here You can
Network Setup
Note: This submenu item appears only
when an internal wireless print server is
installed in the printer.
Select:
• Print Setup Page to print a page that lists the network settings.
• Wireless Setup to view:
– Network Name, which shows the six characters unique to
your specific printer.
– Wireless Signal Quality, which shows the signal strength.
– Reset Network Adapter to Factory Defaults, which lets you
reset the wireless network settings.
• TCP/IP to view the IP Address, IP Netmask, and IP Gateway of
the printer.
• Network Time to choose whether to enable the time server.
Related topics:
•
“Using the control panel” on page 109
Saving settings
In a setting menu, an * appears next to the default setting. To change the setting:
1 From the control panel, press Settings.
2 Press or repeatedly until the setting you want appears.
3 Press :
• To save most settings. An * appears next to the saved setting.
• To select a temporary setting. An * appears next to the selected setting.
Note: The printer reverts to the default setting after two minutes of inactivity or if the printer is turned off.
The Photo Card settings will not time out after two minutes of inactivity or turning off the power but will return
to the default settings when a memory card or flash drive is removed.
To change the timeout feature:
1 Press Settings.
2 Press or repeatedly until Device Setup appears.
3 Press .
4 Press or repeatedly until Clear Settings Timeout appears.
5 Press .
6 Press or repeatedly until Never appears.
7 Press .
To change one or more temporary settings into new default settings:
1 Press Settings.
2 Press or repeatedly until Defaults appears.
3 Press .
Understanding the printer
120
To Next Page
Loading...
