Loading transparencies
You can load up to 50 transparencies at a time.
1 Load transparencies with the rough side facing you. If the transparencies have a removable strip, each strip
should face away from you and down toward the printer.
2 Make sure:
• The transparencies are loaded in the center of the paper support.
• The paper guides rest against the edges of the transparencies.
Notes:
• Transparencies with paper backing sheets are not recommended.
• Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid
ink smudging.
Related topics:
• “Printing transparencies” on page 26
Loading iron-on transfers
You can load up to 10 iron-on transfers at once, but you will achieve best results loading them one at a time.
1 Load iron-on transfers with the print side of the transfer facing you.
2 Make sure:
• You follow the loading instructions that came with the iron-on transfers.
• The transfers are loaded in the center of the paper support.
• The paper guides rest against the edges of the transfers.
Related topics:
• “Printing iron-on transfers” on page 25
Loading custom-size paper
You can load up to 100 sheets of custom-size paper at a time.
1 Load paper with the print side facing you.
2 Make sure:
• The paper size fits within these dimensions:
Width:
– 76.0–216.0 mm
– 3.0–8.5 inches
Length:
– 127.0–432.0 mm
– 5.0–17.0 inches
• The stack height does not exceed 10 mm.
• The paper is loaded in the center of the paper support.
• The paper guides rest against the edges of the paper.
Printing
19
To Next Page
Loading...
