Notes:
• Make sure the PictBridge-enabled digital camera is set to the correct USB mode. For more information, see
the camera documentation.
• The printer recognizes one active media device at a time. If you insert more than one media device, a
message appears on the display prompting you to designate the device you want the printer to recognize.
• If you have a memory card inserted when you connect a PictBridge-enabled camera, an error message will
be displayed telling the you to remove one of the devices.
• If the PictBridge connection is successful, the following appears on the printer display: PictBridge
camera detected. Press
to change settings. If any other message appears, see “Error
messages” on page 187.
• Values selected within the menu items are the settings used for Pictbridge printing if no explicit selection is
made from the camera.
3 Follow the instructions in the camera documentation to select and print photos.
Note: If the printer is turned off while the camera is connected, you must disconnect and then reconnect the camera.
Related topics:
• “Connecting photo storage devices” on page 87
Printing photos from a digital camera using DPOF
Digital Print Order Format (DPOF) is a feature available on some digital cameras. If your camera supports DPOF,
you can specify which photos to print, how many of each, and print settings while the memory card is still in the
camera. The printer recognizes these settings when you insert the memory card into the printer.
Note: Make sure the photo print settings you select match your current printer settings. For information on changing
printer photo settings, see “Understanding the Photo Card menu” on page 114.
1 Load photo paper with the glossy or printable side facing you. (If you are not sure which side is the printable
side, see the instructions that came with the paper.) For more information, see “Loading paper” on page 17.
2 Insert a memory card. For more information, see “Inserting a memory card” on page 87.
3 Press or repeatedly until Print Photos appears.
4 Press .
5 Press or repeatedly until Print DPOF appears.
6 Press Start Color or Start Black.
Related topics:
• “Using the control panel” on page 109
Transferring photos from a memory card to a flash drive
1 Insert a memory card that contains the images you want to transfer. For more information, see “Inserting a
memory card” on page 87.
2 Insert a flash drive into the PictBridge port on the front of the printer. For more information, see “Inserting a flash
drive” on page 88.
Which device is to be displayed? appears on the display.
3 Press or repeatedly until Camera Card or the specific type of your camera card appears.
Working with photos
94
To Next Page
Loading...
