10 Press to save the setting.
11 Make sure the Fax Auto Answer light is on.
When the number of rings you set is detected, the printer automatically receives the incoming fax.
Customizing fax information
Setting up a fax header using the control panel
During the initial setup of your printer, you were prompted to enter your name, fax number, date, and time. This
information is used to create a fax header for faxes you send.
If you have not entered this information:
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
Note: In Australia, skip to step step 11. The last 20 digits of your fax number is your Fax Name or Station ID.
7 Press or repeatedly until Your Fax Name appears.
8 Press .
9 Enter your name using the keypad.
Note: You can enter a maximum of 24 characters.
10 Press to save the setting.
11 Press or repeatedly until Your Fax Number appears.
12 Press .
13 Enter your fax number using the keypad.
Note: You can enter a maximum of 64 numbers and/or the symbols * or #.
14 Press to save the setting.
15 Press Settings.
16 Press .
17 Press or repeatedly until Device Setup appears.
18 Press .
19 Press or repeatedly until Date/Time appears.
20 Press .
Faxing
80
To Next Page
Loading...
