ApexRp Operators Manual
248083480-1 Rev 3 26
Date Settings:
Figure 3-7 Instrument Date and Time Settings
All ApexRp products can have their date and time settings changed in
this screen. Refer to Figure 3-7 to change the Instrument Date / Time
by using the Set to System Time. Corrections to errors can be
reversed by clicking Restore Values. Make sure that desired changes
are followed by clicking the Update Instrument button to save the
changes to the instrument memory. If the instrument is not updated
before the SmartPort Cable is disconnected, the changes will be lost.
Factory Standard Settings
ApexRp Model:
The ApexRp standard network settings are set to the same values for
all ApexRp’s shipped. These values are 10.10.x.xxx for IP, 255.255.0.0
for netmask and 0.0.0.0 as Default Gateway setting. To view the
ApexRp web page, type its IP address into a web browser on a
computer in the same network subnet.
The IT group should provide IP, Mask and Default Gateway values
that meet the local network needs. The ApexRp must be changed to
meet these requirements. Each device will require the IP to be
changed to a new IP, as shown in Figure 3-8, to prevent address
conflicts.
update the instrument
settings before the
SmartPort cable is
disconnected from the
ApexRp.
This button loads the computer system time
and date values into program memory.
This button saves the changes to
the instrument memory.
To Next Page
Loading...
Need help?
General