00
248083440-1 Rev 5 1-1
1 General Safety
Safety
Considerations
Warnings and cautions are used throughout this manual and the reader
should become familiar with the meaning of a warning before
operating the particle counter. Most warnings will appear in the left
margin of the page next to the subject or step to which it applies. Take
care when performing any procedures preceded by or containing a
warning. The classifications of warnings are defined as follows:
WARNING:
There are
no user-serviceable
components inside the
particle counter.
• LASER - pertaining to exposure to visible or invisible LASER
radiation
• Electrostatic - pertaining to electrostatic discharge
• Network Connect - pertaining to communication ports and
instrument damage
LASER Safety
Information
This product is considered to be a Class 1 LASER product (as defined
by FDA 21 CFR, §1040.10 and IEC 60825-1:2014) when used under
normal operation and maintenance. Performing service on the internal
sensor can, however, result in exposure to invisible radiation.
WARNING:
The use
of controls, adjustments
or procedures other than
those specified within
this manual may result in
personal injury and/or
damage to this
instrument.
The particle counter has been evaluated and tested in accordance with
EN 61010-1:2012, “Safety Requirements For Electrical Equipment for
Measurement, Control and Laboratory Use” and IEC 60825-1:2014,
“Safety of LASER Products”.
For further technical assistance, contact our Technical Support Team at
1-800-945-5905 (USA Toll Free), 1-541-770-5905 (Outside of USA).
To Next Page
Loading...
