Lighthouse ApexPortable Operating Manual
3-2 248083440-1 Rev 5
Figure 3-1 ApexPortable Connectors
WARNING: Remove
AC power from Power
Supply, connect DC
cable then connect to
AC.
Always have the AC disconnected from the power supply before
attempting to connect the DC Output Connector to the ApexPortable.
This will prevent damaging the Power Input Connector.
It is suggested that the
ApexPortable be placed in the environment
where it will be used and attached to its power supply for several hours
to ensure its battery is fully charged before putting the instrument into
service.
Set Channels,
Thresholds,
and Alarms
Push the rear power button (see the image above) in to turn the
instument on - it should latch in the ON state. After about 5 seconds,
the unit will display its boot screen then display the Main Screen. The
following screens will display how to enable channels, set alarm levels
and enable the alarms. They are provided as examples and may vary on
individual instruments.
To Next Page
Loading...
