Lighthouse ApexPortable Series - Autostart Mode; Diff+Cuml Zoom

Lighthouse ApexPortable Operating Manual
5-22 248083440-1 Rev 5
touch the center circle to continue the alignment process.
Figure 5-32 Fourth and Fifth Calibration Screens
• Figure 5-32 shows the final alignment screen. Touching the filled
circles properly completes the alignment process.
Figure 5-33 Display Calibration Completed
Note: The screen
alignment function can
also be accessed by
touching the screen when
powering the instrument
on.
The final screen, shown Figure 5-33, instructs the operator to Touch
anywhere on the screen to complete the process. Touch anywhere
on the screen to return to the OPTIONS screen.
Autostart Mode
Autostart mode starts the instrument sampling immediately upon
power up. The instrument will sample based on its configured mode,
delay, start and hold times.
Diff+Cuml Zoom
If Diff+Cuml Zoom is enabled, the Zoomed display will show two
columns of data simultaneously - Differential and Cumulative.
Press & Release
on the filled
circle.
Press & Release
on the filled
circle.
To REPEAT calibration
reset the board while
pressing on the screen
until the calibration
prompt appears.
Touch screen to
continue.