Lighthouse ApexPortable Series - Set ETHERNET Settings

Lighthouse ApexPortable Operating Manual
5-26 248083440-1 Rev 5
Set ETHERNET Settings
Press COMM at the Config screen to display Figure 5-39. Press the
ETHERNET’s toggle button to change it to the green check as shown.
Figure 5-39 Comm ETHERNET Mode
Press the ETHERNET button to open the COMM Ethernet Settings
screen, Figure 5-40, which is displaying the original default values.
Figure 5-40 COMM Ethernet Settings Screen
Press a number button to open the Data entry screen (Figure 5-41).
Enter the new value then ENTER to save and return to the Settings
screen. Press BACK to return to Settings screen and lose any changes.
Press ERASE to delete one digit at a time.
Figure 5-41 IP Data Entry Screen