Operate the ApexPortable
248083440-1 Rev 5 5-47
• Press the FLOW button to display screen shown in Figure 5-73.
Figure 5-73 Reports Air Flow Set Up Screen
• Choose the appropriate type of air flow (Unidirectional, Non-
Unidirectional), then press the BACK button to return to the
SETUP screen, which will display the values that were configured
so far. Press the PARTICLE button to enable or disable particle
channels as shown in Figure 5-74 and press BACK to return to
Setup screen.
Figure 5-74 Reports Particle Set Up Screen
• Press the SAMPLE button to configure the number of Cycles,
Delay time, Hold time, Sample time and Volume. See Figure 5-75.
Figure 5-75 Reports Sample Set Up Screen
To Next Page
Loading...
