114 THE BLUE BOX LT GR1404/08 LT INSTALLATION GUIDE
LCDBB1404/08IG03Sept08
INSTRUCTIONS
PANEL MOUNTING
Use the drill template to pre-drill 1.
mounting holes for appropriate
screw fasteners and mount panel.
Backplate can be removed at rough-in.
LINE vOLTAGE CONNECTIONS
Connect to power (120V or 277V) 2.
neutral and ground lugs. Connect
to dedicated breaker (see next
page for emergency loads).
Follow the Panel Schedule on 3.
the inside door. If panel is factory
pre-programmed connect per
line and load directions. If not,
document field-made connec-
tions. (back page)
Tighten and then re-tighten lugs 4.
to 18 in/lbs.
Tip: Fault-check each circuit prior to en-
ergizing relays.
LOW vOLTAGE CONNECTIONS
Follow the “System Start-Up & 5.
Cabling Guide” to make bus con-
nections using Cat. 5 with RJ45s.
Make-up connections to optional 6.
low voltage accessories:
Modem (see back page)7.
Photocell (see next page)8.
For contact closure devices use 9.
the optional DI Card (next page).
START UP
To start-up the panel as part of a 10.
new system refer to the “System
Start-Up & Cabling Guide”.
To start-up the Blue Box in an
existing network, refer to “Add-
ing New Devices” in “The Blue
Box LT O&M Manual”.
Blue Box Mounting Holes (4).1.
Back Plate Mounting Screws.2.
RJ45 sockets for GR 2400 bus.3.
Photocell Input (master 4.
only). The Photocell may
control any relay(s) in any
panel(s).
Optional Modem. Analog 5.
phone line connects to RJ-
12 socket.
Relays (line and load lugs).6.
Dual-voltage (120V or 7.
277V)power supply.
(Optional) Digital Input 8.
Card. DI 14 (or DI6 with
enable/disable) inputs.
Terminator pins. Terminate 9.
the bus only after the “Sys-
tem Start-Up and Cabling
Guide” has been completed.
White door and back of DTC 10.
clock (master panel only).
Grounding LUG.11.
1
3
2
4
10
5
6
7
8
9
1
2
3
2
4
10
5
6
7
8
9
low voltage only line voltage only
For a complete parts list refer to the Blue Box LT O&M Manual
11
11
To Next Page
Loading...