Lighting Controls Blue Box LT Series - Programming Switches or DI Inputs

THE BLUE BOX LT PROGRAMMING 71
LCDBBP03Sept08
PROGRAMMING SWITCHES OR DI INPUTS
To Navigate to Digital Switch or DI Card
TAB to start.1.
TAB to PROGRAM SWITCH and ENTER to 2.
select.
USER MENU
MANUAL OVERRIDE
REVIEW SCHEDULE
GROUP LOADS
PROGRAM SWITCH
SETUP MENU
If needed SCROLL to the correct Page.3.
SWITCHES PAGE 1-2
#04: switch 4
#05: switch 5
#06: switch 6
#07: switch 7
#08: switch 8
#09: switch 9
#10: switch 10
Indicates Page 1 of 2
If cursor starts here,
multiple pages exist
with switches on each.
SCROLL to navigate
to the correct page.
TAB to the correct Switch.4.
ENTER to select (Switch 11).5.
This is the name of
the switch.
This is the address of
the switch.
SWITCHES PAGE 2-2
#11: Switch 11
#12: switch 12
#16: switch 13
TAB to the correct Button/Input.6.
ENTER to select.7.
SELECT BTN SWI ID#11
SETUP PAGE 1-1
B1: BUTTON 1
B2: BUTTON 2
B3: BUTTON 3
B4: BUTTON 4
B5: BUTTON 5
B6: BUTTON 6
Switch ID#11
SETUP is for advanced
programming only!
Button6, Switch ID11
To Select Control Type
Before adding or deleting loads it is important to
determine the Control Type (see the Control Types
section of this manual).
Tip: Most common Control Types for switches are
TOGGLE, ON, and OFF.
SCROLL to select Control Type.1.
SWI ID11-6 TOGGLE
EDIT: LCP-1 LOAD-1
Indicates Control Type
Note: Switches may control any number of loads. If
more than 8 loads are selected, the system will create
a Group upon exiting. When prompted to create a
new Group, select “YES” (See Groups Section for
more information).
To Add or Delete Loads for all Control Types
(except Mixed Mode)
TAB to LCP 1.1.
SCROLL to select LCP (1,2,3 etc.).2.
TAB to LOAD 1.3.
“Toggle” Control Type
has been selected
LCP1 Relay1 has been
added to the Load
Summary
SWI ID11-6 TOGGLE
EDIT: LCP-1 LOAD-1
LCP1: 1
SCROLL to the LOAD you want to add or 4.
delete.
ENTER once to select LOAD - it will be added to the 5.
Load Summary.
ENTER again to delete LOAD from the Load 6.
Summary.
Repeat to add or delete more LOADs.7.
EXIT up to main menu.8.
To Add or Delete Loads for Mixed Mode: