Network
Network tab in Settings menu
Network Settings
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Restart http(s) services button is also needed.
INFO:
Network Services
HTTP/HTTPS
the detailed list about the additional available features in the summary table of the Basic Network Security
section).
HTTPS protocol encrypts the transferred data to keep it protected. For more details about the HTTPS, see
the section.
▪ Enable/Disable HTTP/ HTTPS port:
should be opened to reach these functions.
ATTENTION! Please ensure proper time and date setting in the device because it affects the self-signed
▪ Require Authentication over HTTP/HTTPS: authentication helps limit the access to the device by setting
a username (admin) and password. For more details, see the Basic Authentication section. No
password is set by default, the authentication can be enabled after setting a password.
▪ Restart HTTP(S) Services is required after the authentication settings changed.
Serial over IP
The signal route of the serial- IP transmission can be broken by disabling the serial over 8001 or 8002 port.
For more details about the RS-232, see the Serial Interface section.
LW3
Enable LW3 over 6107
WARNING!
series switcher can be controlled only with protocol commands via http(s). Reset to Factory Default
Settings can re-enable the network interfaces.
Credentials
password string, so it can not be queried. #password
ATTENTION! Authentication feature in MMX2 series is not equal to the Cleartext login feature in the
Advanced Control Pack in the TPS family extenders.
#dhcp #ipaddress #network #portblock #network #ipaddress #http #https
To Next Page
Loading...
Need help?
General
