Lightware MMX2 Series

 MMX2 series – User's Manual 90

Resetting the Emulated EDIDs
Command and Response
ç 
æ mO·
Parameters
Parameter Parameter description  
<user_edid> The emulated EDID memory of the desired input port.
U1-U14
User EDIDs
Example
ç 
æ 
Calling this method switches all emulated EDIDs to a factory default one. See the table in the Factory EDID
 section.

Setting the DHCP State
ATTENTION!  applySettings method

applySettings
Command and Response #dhcp #network #ipaddress
ç <dhcp_status>
æ pw·/V1<dhcp_status>
Parameters
If the <dhcp_status> parameter is true, the current IP address setting is DHCP, if the parameter is false, the
current IP address is static.
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value, and will reboot the device.
INFO:  The current setting can be queried by using the GET command.
Changing the IP Address (Static)
Command and Response
ç <IP_address>
æ pw·/V1<IP_address>
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value, and will reboot the device.
INFO:  The current setting can be queried by using the GET command.



