Lightware MMX2 Series

  

OutputSignalType
Command and Response #signaltype
ç <out>.OutputSignalType=<signal_type>
æ pw·<out>.OutputSignalType=<signal_type>
Parameters
Parameter Parameter description  
<signal_type> Signal type setting
Auto
The outgoing signal type is HDMI.
DVI

Example
ç 
æ 
EmbeddedAudioPresent
ç <port>.EmbeddedAudioPresent
æ pr·<port>.EmbeddedAudioPresent=<embedded_state>
Parameters
Parameter Parameter description  
<embedded_state> It shows if the video
contains audio or not.
true
There is embedded audio in the video signal.
false
There is no embedded audio in the video signal.
Example
ç 
æ 
EmbeddedAudioMute
ç <port>.EmbeddedAudioMute=<mute_state>
æ pw·<port>.EmbeddedAudioMute=<mute_state>
Parameters
Parameter Parameter description  
<mute_state> It shows if the
embedded audio is
muted or not.
true
The embedded audio is muted.
false
The embedded audio is unmuted.
Example
ç 
æ 
Output5VMode

Command and Response
ç <out>
æ <out>
Parameters
Parameter Parameter description  
 
On
Off


Example
ç 
æ 
HDCP Capability (Output Port)
HDCP capability of the connected sink device can be queried at each output port. See more information in
the HDCP Management section.
Command and Response #hdcp
ç <out><hdcp_ver>
æ <out><hdcp_ver>
Parameters
Parameter Parameter description  
<hdcp_ver> The HDCP capabality is
reported from the sink.
N/A
Sink is not connected or the HDCP-capability cannot
be determined.
None
The connected sink is non-HDCP compliant.
HDCP 1.4

HDCP 2.2
The connected sink supports HDCP 2.2 capability.
Example
ç 
æ 



