Lightware SW4-TPS-TX240 - Change the Gateway Address (Static); Apply Network Settings; Ethernet Port Configuration; Change the Subnet Mask (Static)

  


Set the DHCP State
ATTENTION!  applySettings method

applySettings
Command and Response #dhcp #network #ipaddress
ç 
æ 
Parameters
If the  parameter is truefalse the

Example
ç 
æ 
ç 
æ 
 The applySettings method will save and apply the new value and results the device to reboot.
 GET command.
Change the IP Address (Static)
Command and Response
ç 
æ 
Example
ç 
æ 
ç 
æ 
 The applySettings method will save and apply the new value and results the device to reboot.
 GET command.
Change the Subnet Mask (Static)
Command and Response #ipaddress
ç 
æ 
Example
ç 
æ 
ç 
æ 
 The applySettings method will save and apply the new value and results the device to reboot.
 GET command.
Change the Gateway Address (Static)
Command and Response
ç 
æ 
Example
ç 
æ 
ç 
æ 
 The applySettings method will save and apply the new value and results the extender to reboot.
 GET command.
Apply Network Settings
Command and Response
ç 
æ 
Example
ç 
æ 




