Lightware SW4-TPS-TX240 - Set the subnet mask; Set the gateway address; Apply network settings; Enable;Disable the ethernet port

  

Set the Subnet Mask

Command and Response
 
 
Parameters
 section.
Example
 
 
 

mask is not valid.
Set the Gateway Address
Gateway address can be set as follows.
Command and Response
 
 
Parameters
 section.
Example
 
 
             


Apply Network Settings

Command and Response
 
 
Example
 
 

Command and Response
 
 
Parameters
If the  parameter is 0, the port is disabled. If its value is 1, the port is enabled.
Example
 
 



