RS-232 Message Sending
Sending a Message (ASCII-format) via RS-232
allows
characters. For more information see the  section.
Command and Response #message
 ç )
 æ 
Example
 ç 
 æ 
Sending a Text (ASCII-format) via RS-232
does not require 
Command and Response
 ç )
 æ 
Example
 ç 
 æ 
Sending a Binary Message (HEX-format) via RS-232
does not require 
Command and Response
 ç )
 æ 
Example
 ç 
 æ 
Using Hexadecimal Codes
sendMessage command:  CALL /MEDIA/UART/P1:sendMessage(C00\x0D)
tcpMessage command:  CALL /MEDIA/ETHERNET:tcpMessage(C00\x0D)
udpMessage command:  CALL /MEDIA/ETHERNET:udpMessage(C00\x0D)
 ▪ C00
 ▪ \x
 ▪ 0D