Lightware SW4-TPS-TX240 - Factory Default Settings; Applied Ports (Network Settings)

  

Factory Default Settings
Parameter 
Crosspoint settings (for SW4-TPS-TX240 and -TX240-Plus)
 
Audio 
Video input port settings (HDMI, DVI-D, DP)
 Enabled
Emulated EDID 
Video output port settings (TPS, HDMI)
Autoselect Disabled
Test pattern mode Off
Test pattern resolution 
Test pattern Bar
 Auto
 Auto
 Always on
 Auto
Analog audio input port settings
 
Balance 
Gain 
Network settings
 
 
 
 Disabled
 
 
 
RS-232 settings
Control protocol 
Baud rate 
Databits 
 None
 
Parameter 
Operation mode 
 Enabled
 
 
IR port settings
 Enabled
 
 
 
 
GPIO port settings
Direction Input
Output level 
#factory
Applied Ports (Network Settings)



Affected
software
Protocol Port nr.
   
 
 
Device Discovery   
   
   
   
   
   
   
   



