Lightware SW4-TPS-TX240 - BAUD Rate Setting; Protocol Setting; Running an Immediate Event Action; Port Configuration

  


Command and Response
ç 
æ 

Parameters
The 
Example
ç 
æ 
 ActivePropertyTimeout is elapsed only.
Set the Active Timeout
ActiveRx, ActiveRxHex, ActiveHash properties after the elapsed

Command and Response
ç 
æ 
Parameters
The
Example
ç 
æ 
Running an Immediate Event Action


Command and Response
ç 
æ 
Parameters
The 

Example
ç 
æ 

ATTENTION!  
GET /MEDIA/UART/P1.BaudRate.
ATTENTION!  Operation mode

   section.
Protocol Setting
Command and Response #protocol #rs232 #rs-232 #serial
ç 
æ 
Parameters
If the  parameter is 0 the device is set to receive LW2 commands. If the value is 1 the device is set
to receive LW3 commands.
Example
ç 
æ 
BAUD Rate Setting
Command and Response
ç 
æ 
Parameters
  
 The Baud rate of the serial port. 012345
67
Example
ç 
æ 



