Details: MAIN ROW
6•23
MAIN ROW
DRIVE – Controls the volume of the signal going into the preamp. Higher levels can
give you additional preamp distortion. The DRIVE control is disabled when one of the
Acoustic Simulation Amp Models is selected (you don’t really want to distort your
acoustic guitar sound anyway, do you?). The range is 0-99.
BASS / MID / TREBLE – As we covered in great detail in the chapter on Amp
Models, these controls are made to emulate the tone controls of the amps that were
the inspirations of the AX2 Amp Models. You can also access these controls from the
AMP MODEL Edit Row (fourth from the top), so you can conveniently tweak them
while selecting your amp model and setting other details about it. (0-99)
CHANNEL VOLUME – This is the output level to the power amp. Use this control
to balance levels between different channels - for instance, you might want to turn up
a lead channel, and set a rhythm channel at a relatively lower volume. (0-99)
DELAY/REVERB – This is a master effects level control for both the Delay and
Reverb effects. (0-99)
To Next Page
Loading...
Need help?
General
