Tweaky Stuff: SYSTEM RESETS
10•1
TWEAKY STUFF
SYSTEM RESETS
There are two resets available on the AX2.
The soft reset zeroes all of the Global settings – Gate/Hum per Sound, Aux per Sound,
MIDI channel, Global Tone Controls, and the Knob Mode (Instant Access or Pass
Through) – but leaves your stored User channels alone.
The hard reset takes every setting in the AX2 back to factory default settings, as if
your AX2 had just come out of the box. All your User memories are blanked, and
loaded with a copy of the Preset channels (just like when the AX2 was first
programmed at Line 6).
The hard reset will erase all of your stored user presets and replace them with the
original presets, so be sure to back up any presets you want to keep before performing a
hard reset.
PERFORMING A SOFT RESET
Turn the AX2 off. Press and hold in the Tuner and Compare buttons, and keep
holding as you turn the AX2 on. Global settings are now reset to the factory standard:
Gate/Hum per Sound. . . . . . . . . . . . OFF
Aux per Sound . . . . . . . . . . . . . . . . . OFF
MIDI Channel. . . . . . . . . . . . . . . . . . . 1
Global Tone Controls . . . . . . . . . . . . All Zero
Knob Mode . . . . . . . . . . . . . . . . . . . . Instant Access
PERFORMING A HARD RESET
CAREFUL! YOU’RE ABOUT TO WIPE THE MEMORY OF YOUR AX2, DESTROYING ANYTHING
YOU MIGHT HAVE SAVED IN THE USER CHANNELS.
Doesn’t scare you? Then turn the AX2 off. Press and hold the User/Preset and Save
buttons, and keep holding as you turn the AX2 on. That’s it.
To Next Page
Loading...
Need help?
General
