Tutorial: MAKING YOUR BLANK CHANNEL
7•2
Press the top Row Select button to activate the AUX/MIDI Row. Set the Aux Input
Mix, Bass, Treble, and Reverb level to zero, MIDI Channel to 1, and just leave
Transmit Sounds alone.
Press the top Row Select button again to activate the NOISE GATE Row. The little
red arrow should be pointing to it. Set the Noise Gate off, Threshold at zero, Decay at
25, and Hum Canceller to off. Set Gate/Hum Per Sound and Aux Per Sound to ‘Chn.’
Press the second from the top Row Select button to choose the COMP/PEDALS Row.
Set Compression Level to zero, Volume Pedal to ‘Pst,’ Distortion Box to 3.4 (sort of a
middle ground), Wah Type to 1, Wah Depth to 99, and Auto-Volume Attack to Off.
Press the second from the top Row Select button again to activate the Amp Model
Row. Set Model Select to 1, skip Bass/Mid/Treble (since these are the same as the
MAIN Row controls), set the Bright Switch off, and set the Amp Model Out Level to
99.
Press the GRAPHIC EQ Row Select button, and set all the controls flat (12 o’clock),
with Presence at 50.
Select the TREMOLO/CAB Edit Row, and set Tremolo type to 1, Speed to 35, Depth
to 35, and Shape to zero. Set the Cabinet Type to zero, and Stereo Spread to off.
DELAY: Set Delay Type to 1, Main Delay Time to 30, Delay Time Offset to zero,
Feedback to 0, Dynamic Delay to zero, and Delay Level to 99.
CHORUS: Set Chorus Type to 1, Speed to 7, Depth to 85, Feedback to zero, Chorus
Shape to 4, and Chorus Level to 50.
REVERB: Type 1, Predelay zero, Decay 30, Tone 50, Diffusion 50, and Level 99.
FX ON/OFF: Set them all off.
Now, press SAVE. The AX2 display will flash. It should be flashing U32, and the
Channel D button should be lit. If not, use the Bank UP/DOWN and CHANNEL D
button to make it so. Press SAVE a second time. Congratulations!
To Next Page
Loading...
Need help?
General
