Lode BV Excalibur Sport
50
2 t=00:48 θ=01:12
P= 23 W 61 rpm
♥= 91/min t♥=100/min
rec rec
ecg trigger
CONTRAST
p-in/out analog
sett Cont
2 t=00:48 θ=01:12
61 rpm ♥= 91/min
E= 1.43kJ P= 20W
rec rec
Selecting the target HR parameter will show you the target heart rate programmed in the heart
rate controlled protocol beside the actual heart rate. For instance:
Selecting the energy parameter will show you the total amount of mechanical energy
delivered by the test subject going into the ergometer in the form of mechanical motion,
during the exercise test. For instance:
Instead of 2 items you can show 4 items out of your selection at once, they will scroll in
groups of 2. When you select 4 parameters, there will be no scrolling but a fixation on the
display of these parameters. You can program the parameters (also up to 4 without scrolling)
at the basic control panel as well, but you have to switch the control over to the basic side first
as is described in the next paragraph.
The menu SETTINGS will give you the opportunity to select PROTOCOL as a default
startmenu besides the previously described menus ANALOG, MANUAL, TERMINAL and
SYSTEM PARAMETERS.
An extra option for the Programmable control unit in the menu SETTINGS is the
CONTRAST adjustment for the P-display.
Adjusting contrast shows direct effect on the display.
To Next Page
Loading...
