Lode 925900 - EOS and Recovery Time Programming; B.3.8.2 Example Protocol Programming

Lode BV Excalibur Sport
55
EOS End Of Stage
automatic measurement at every end of the exercise step with the possibility to
program the measurement time before the end of the stage.
Recovery time If you have programmed automatic BP measurement in the protocol, either
EOS or repeat you get afterwards the possibility to program the repeat time of the BP
measurement during the recovery stage:
Leaving the time to zero during BP
programming (repeat, EOS or rec.) is equal to no BP measurement.
After the programming of the BPM the menu PROTOCOL will appear again. You can RUN
EDIT or DELETE one of the protocols now.
B.3.8.2 Example Programming Protocol
For the purpose of clarification we will program a demonstration protocol with all
possibilities. Execute the following steps to get into the programming mode.
1. Select PROTOCOL in the MAIN MENU, confirm ( ).
2. Select PROTOCOL edit, confirm ( ).
3. Select New, confirm ( ).
4. Give a protocol name: test.
5. With the ▼▲ keys you can scroll through the alphabet confirm, use NEXT ( ) to go to
the next position.
6. The program screen appears, the underscore showing the programming parameter:
PROGRAM BPM
time to EOS = 01
min
back ok
Program BPM
Rec.time = 02
min
back ok
Program BPM
Measurement
EOS
esc ok