Logic DLC NET Series

To Next Page

To Previous Page

USE AND MAINTENANCE MANUAL – DLC

NET

Series

Use as interface with indicator

LOGIC S.r.l. - M0145Db.docx

Mod. L0006A01 of 30/05/2016

Page 46 of 78

 : to perform a zero calibration

 : to configure the instrument

 : to perform the calibration operations

 : for the real-time set clock (only with expansion board -EB)

 : for the setpoint set (only with expansion board -EB)

When the desired menu is selected, press the button to confirm and enter.

For the menu you must press simultaneously and .

Press at any time to cancel and return to the weight display screen.

5.3.3 Net / gross weight

displaying

On the main screen, the system shown the actual weight value.

By pressing the button you can switch the display from gross weight to net

weight and vice versa. Function mode is indicated by the status led and

If you push the button you can make the temporary tare zeroing of the net

weight display.

Main Page

Figure 1. Equipment Back Serigraphy11
Figure 2. Diagram of Operation and Power Supplies13
Figure 3. Mechanical Drawing of DLC NET15
Figure 4. DLC NET -WM Mechanical Drawing16
Figure 5. DTR NET -WM Mechanical Drawing16
Figure 6. Layout of the Terminal Blocks, Profibus-DP18
Figure 7. Layout of the Terminal Blocks, Profinet18
Figure 8. DLC NET -WM Terminals (Model with On-Board Keyboard)19
Figure 9. DTR NET -WM Terminals (Model with External Keyboard)19
Figure 10. Power Supply Connection20
Figure 11. Load Cells Connection 6 Wires21
Figure 12. Load Cells Connection 4 Wires21
Figure 13. Load Cells Connection 6 Wires with Zener Barrier Z-SET3-PF22
Figure 14. Load Cells Connection 6 Wires with Active Barrier D1063S23
Figure 15. Connection to the Junction Box JBOX-V3(EX1)24
Figure 16. Connection of DLC25
Figure 17. Connection of DLC26
Figure 18. Instrument Connection to Profibus-DP28
Figure 19. Instrument Connection to Profinet29
Figure 20. Connection to External Buttons through Potential-Free Contacts30
Figure 21. External Buttons Connection from Active Source31
Figure 22. Connection to Setpoint Output31
Figure 23. Input and Output Connections for Dosing32
Figure 24. Analog Output Connection 0-20 Ma or 4-20 Ma33
Figure 25. Printer Connection through RS23234
Figure 26. Signal Chart for the Data Weight Reading through Parallel Output35
Figure 27. Connection for Parallel Interface Type PNP36
Figure 28. Connection for Parallel Interface Type NPN37
Figure 29. Switch SW2-1 for Setting Speed ADC39
Figure 30. Termination Resistance Setting RS485 Serial Port39
Figure 31. Hardware Setting for Siemens PLC40
Figure 32. Reading Instrument with PLC42
Figure 33. Operator Interface of DLC43
Figure 34. Operator Interface with Logic DLC3-RD43
Figure 35. Operator Interface with BEKA44
Figure 36. Application of the Instrument as a Batcher61
Figure 37. Timing Activation Outputs for the Dosing of Automatic Components62

Logic DLC NET Series

Table of Contents