Logic DLC NET Series

USE AND MAINTENANCE MANUAL – DLC
NET
Series
Use as a batcher
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
Page 70 of 78
appropriate corrections to ensure that anomalies fall and press
again.
 If the checks are positive, the instrument gives consent to the dosage and
appropriately controls the valves according to the pre-action parameters
( ) and in flight amount ( ) set and the logic described in paragraph
6.1.2.
 The product begins to flow and the weight indicator in the display begins to
increase.
 On the instrument are activated two led:
o Flashing led / / / , indicating the automatic
component dosing
o Flashing led , which indicates that there is a recipe in
progress. This led will remain active until the recipe is not finished
 It is possible pause the dosage by pressing the button. The display
will show . Press to resume.
 When it reaches the setpoint minus the in-flight amount, the system waits
for the waiting time of the in-flight set amount and shows the written
, acquiring the data weight for the printer.
 At this point, the led corresponding to the component dosing is steady on,
indicating that the filling process is ended. The led continues to blink
and the dosage is terminated.
 To dose a new automatic component repeat the full procedure. To dose a
manual component, follow the instructions in section 6.4.3.
6.4.3 Dosing of manual
components ( )
In addition to the automatic components, it can be dose manual components that
are stored for printing.
To dose the manual component follow these steps:
 Press the button to enter the ingredients selection menu ( ).
 The display will show the written ( ), corresponding to the first
automatic ingredient.
 Press at any time to cancel and return to the previous menu.
 Use the button until the manual component words ( ).
 The display shows the index of the next manual component to be dosed,
starting from 1.
 Press to confirm and begin the dosing of the first manual
component.