18. Rotate the log 180° so that the freshly sawn surface rests on the log bed.
Turn the log through 180° so that the freshly sawn side faces towards the log bed.
Lower the log supports and the log clamps so that they will not come into contact with the blade and
clamp the log in position. Continue sawing until you reach the desired cant width.
Rotate the log 90° so that one of the freshly sawn sides rests at against the log supports, and then clamp
the log in position. Now you can make the third cut and then produce boards. Here, you may need to
compensate for taper in the log. Lower the log support gradually and cut up the log with the bark facing
down.
Rotate the log 90° so that one of the freshly sawn sides rests at against the log supports, and then clamp
the log in position.
USER MANUAL
105
To Next Page
Loading...
