The User Interface
152
When a frequency is selected from the list, the current setting for the receiver P and Q
channel potentiometer positions together with the balance can be viewed.
When the screen is exited, the detector will restore the current running products' operating
frequency.
Tap on the arrow to the right of the field to display a drop down list of frequencies and select
the required frequency.
Pot position
The potentiometer positions for the P and Q channels of the selected operating frequency are
displayed.
The potentiometers are used to select the signal size that is injected into each channel to
balance them out.
These values are automatically set for the selected frequency by the software when the
AutoBalance feature is used.
The potentiometer positions can be manually adjusted within this screen, but this is not
recommended.
Balance setpoint
The target value for the balance between the P and Q channels is displayed. The default
value is 100.
Balance
The measured balance between the P and Q channels on the receiver board is displayed as a
read-only value.
When the detector has been configured correctly, the measured balance will generally be
lower than the balance setpoint.
If in doubt contact your local Loma service centre for assistance.
Auto configure
Selecting this option starts the AutoBalance process for all operating frequencies. The
process commences by resetting the potentiometer positions for the P and Q channels for
each frequency to 50. The configuration progress is displayed and will close automatically
upon completion.
Tap on the button to start the auto configure process.
To Next Page
Loading...
