Loma IQ3+ST - Batch Control

The User Interface
105
 System faults
Tapping in this option check box will enable exporting of the System Faults
Log.
 Setup
Tapping in this option check box will enable exporting of the Setup Report
.
 Learn
Tapping in this option check box will enable exporting of the Learn Report
.
 Status
Tapping in this option check box will enable exporting of the Status Report
.
 Batch
Tapping in this option check box will enable exporting of the Batch Log
and also enable the
Batch feature for use. The Batch Control icon is then displayed in the System Settings screen
to provide access to the
Batch Control screen.
 Shift
Tapping in this option check box will enable exporting of the Shift Log
and also enable the
Shift feature for use. The Shift Control icon is then displayed in the System Settings screen to
provide access to the
Shift Control screen.
 PVS
Tapping in this option check box will enable exporting of the PVS Log
.
 Form Feed
Tapping in this option check box will include the form feed character at the end of the
exported log or report file. This option is selected by default.
 Carriage return
Tapping in this option check box will include the carriage return character at the end of the
exported log or report file. This option is selected by default.
Batch Control
Purpose
The Batch Control screen is displayed by tapping on the Batch Control icon in the System Settings
screen.
The Batch Control icon is only displayed for selection in the System Settings page if the
Batch option has been enabled in the Report Options screen.
The purpose of the screen is to define what constitutes a batch, which could be a specified number of
packs or any number of packs passed through the detector during a specified time period.
Screen Contents
The screen contents will vary depending on the Batch units option selected as follows:
 Packs option selected:
o Batch packs
Tap in the field to display a pop-up numeric keyboard and enter the number of packs that
signifies a batch.