Loma IQ3+ST - Enabling the PVS Feature

Operating Instructions
200
Enabling the PVS Feature
To start using PV testing, proceed as follows:
1. In the System Settings screen, tap on the User Options icon to display the User Options
screen.
2. Then tap on the PVS option check box to enable the option.
3.
Tap on the Back button
to display the Save Settings pop-up screen. Then tap on the
green tick 'OK' button to save the changes and close the screen.
4. In the System Settings screen a PVS icon is now displayed. Tap on the icon to display the
PVS Setup screen.