Loma IQ3+ST - Page 190

Operating Instructions
180
2. Then tap on the Service icon to display the Service
screen.
3. Tap on the GP I/O icon to display the GP I/O screen.
Note that the detector will stop inspecting whilst you are in any Service screen, as indicated
by the red message Not Inspecting!displayed at the bottom of the screen.
4. You can now select the required options. See the GP I/O screen section for further details.
6.
Once you have selected the options, tap on the Back button
to display the
Save Settings
pop-up screen. Then tap on the green tick 'OK' button to save the changes.