www.longer3d.com support@longer3d.com
3.6. Leveling interface
Leveling is a key step in ensuring successful printing. Before leveling,
please make sure that the nozzle is clean and no residual filaments to
avoid affecting the leveling result. If the nozzle is close to the platform,
the nozzle will not be able to extrude normally, and the PEI film will be
easily scratched; on the contrary, if the nozzle is far away from the
platform, the adhesion between the model and the PEI film will be
insufficient, resulting in printing failure. The LK4X printer supports
manual and automatic leveling. Before auto-leveling, it is strongly
recommended to manually level the print bed to ensure that it is flat.
(1) Manual leveling
Click Leveling, and then click the five points in turn to move the nozzle
different points to level the hot bed.
To Next Page
Loading...
