www.longer3d.com support@longer3d.com
Safety precautions
1) The temperature of the nozzle parts can reach 250 °C during the
operation of the machine. To ensure your safety, it is forbidden to touch
the model and nozzle directly with your hand while the printer is printing
or cooling.
2) During the operation of the machine, it is forbidden to reach into the
machine to prevent pinching.
3) The working voltage is 110~220V AC voltage 50HZ AC. The three-pin
socket must be grounded. Do not use other power sources to avoid
damage to components or fire, electric shock and other accidents.
Note: Before powering on, please check whether the input voltage value
of the switching power supply meets the voltage standard of the country
or region.
4) When the machine is working continuously for ≥ 96 hours, it ia
advised to stop for 1-3 hours.
5) The filaments are not used after unpacking or for a long period of time
after the print model is completed. The filaments should be taken out of
the printer and sealed to prevent the filaments from being exposed to
the air for a long time, causing moisture and affecting the print quality.
To use this printer, it is recommended to use the filaments provided by
To Next Page
Loading...
