8-31
8.25 Parameter Initialize / Lock
z Parameter initialize
Group Display Parameter Name Range Default
Function
group 2
H93 [Parameter initialize] 0
- 0
1 4 groups initialize
2 Drive group initialize
3 F 1 group initialize
4 F 2 group initialize
5 I/O group initialize
Select the group to be initialized and perform it in H93 code.
Press Enter (z) key after setting in H93. H93 will be displayed again after initialization is
complete.
z Password register
Group Display Parameter Name Setting Range Default Unit
Function
group 2
H94 [Password register] -
0 ~ FFFF 0
H95 [Parameter lock] - 0 ~ FFFF 0
Register password for Parameter lock (H95).
Password should be Hex decimal. (0 ~ 9, A, B, C, D, E, F)
CAUTION
After setting modification lock function of H95, Do not forget the registered
password. if you try to release lock, you need the registered password.
Factory default password is 0. Enter the new password except 0.
Follow the steps below when you register the password for the first time.
Step Note Keypad display
1 Move to H94 code. H94
2 Press Enter (z) key twice. 0
3 Register password. (Ex: 123) 123
4 123 will blink when Enter (z) key is pressed. 123
5 Press Enter (z) key. H94
To Next Page
Loading...
Need help?
General
