4-5
4.4 How to change the codes in a group
z Code change in Drive group
Drive group
1
-. In the 1
st
code in Drive group “0.00”,
press the Up (S) key once.
2
-. The 2
nd
code in Drive group “ACC” is
displayed.
-. Press the Up (S) key once.
3
-. The 3
rd
code “dEC” in Drive group is
displayed.
-. Keep pressing the Up (S) key until the
last code appears.
4
-. The last code in Drive group “drC” is
displayed.
-. Press the Up (S) key again.
5 -. Return to the first code of Drive group.
♣ Use Down (T) key for the opposite order.
z Code jump
When moving from the “F 0” to the “F 15” directly
FU group 1
1
-. Press the Ent (z) key in “F 0”.
2
-. 1 (the code number of F1) is displayed.
Use the Up (S) key to set to 5.
3
-. “05” is displayed by pressing the Left
(W) key once to move the cursor to the
left. The numeral having a cursor is
displayed brighter. In this case, 0 is active.
-. Use the Up (S) key to set to 1.
4
-. 15 is set.
-. Press the Ent (z) key once.
5 -. Moving to F 15 has been complete.
♣ Function group 2 and I/O group are settable with the same setting.
To Next Page
Loading...
Need help?
General
