LSIS XBC-DR30E - Page 223

(6)
Revolution/Unit time
While the Flag about the number of revolution per unit time is On, it counts the number of input
pulses for a specified time.
(a) Setting
1) Set the unit time and the number of pulse per 1 revolution.
Setting value is saved at the following special K area and user can designate directly.
Class
Device per each channel (Word)
Setting
range
Ch.0
Ch.1
Ch.2
Ch.3
Ch.4
Ch.5
Ch.6
Ch.7
Unit time K322 K352 K382 K412 K2242 K2272 K2302 K2332
1~60000㎳
Pulse/Rev
value
K323 K353 K383 K413 K2243 K2273 K2303 K2333 1~60000
2) In case of using Rev/unit time function, enable the following special K area
Class
Device per each channel (Word)
Operation
Ch.0
Ch.1
Ch.2
Ch.3
Ch.4
Ch.5
Ch.6
Ch.7
Rev/unit
time
command
K2605 K2705 K2805 K2905 K21805 K21905 K22005 K22105
0: disable
1: enable
3) Rev/unit time value is saved at the following special K area.
Class
Device per each channel (Word)
Ref.
Ch.0
Ch.1
Ch.2
Ch.3
Ch.4
Ch.5
Ch.6
Ch.7
Rev/unit
time
K264 K274 K284 K294 K2184 K2194 K2204 K2214 -
www.behaotomasyon.com
www.behaotomasyon.com