(g) T
he example that number of pulse per 1 revolution set to ‘10’ and time is set to 60,000 ms
is as shown below.
(7) Count latch
When Count latch signal is On, present count value is latched.
▪ Setting
If present counter value is to latch, Count Latch function is set ‘Use’.
Class
Device area per channel
Operation
command
K2606 K2706 K2806 K2906 K21806
K21906
K22006 K22106
0: disable
1: enable
▪ Count latch function is operated when Count latch signal is On. Namely, counter value is not
cleared when power supply Off =>On and mode change, it is counted from previous value.
▪ In latch counter function, internal or external preset function has to use for clearing present
value.
Command
1000
500
0
300
400
700
500
350
60000㎳ 60000㎳ 60000㎳ 60000㎳
10 30 20 15
To Next Page
Loading...