LSIS XBC-DR30E - Page 290

Chapter 13 Installation and Wiring
13 4
(2) System design circuit example (In case of using ERR contact point of power module)
Checking DC
current
Signal input
Timer setting
which DC input
signal is
configured.
Output for warning
(Lamp or buzzer)
(Emergency stop,
stop by limit)
Stop by ERR
Error Off
Configure part that
lead opposite operation
or breakdown such as
interlock circuit
forward, reverse
revolution by external
interlock circuit
Pm
Pm
Tm
Pm
Tm
Pm
Pn
Pm
F0045
F009C
ERR
ERR contact point off
to output device
power off
RA3
Voltage relay
equipped
Start stop circuit
PLC RUN output
Available to start as
RA1
Start sequence of power
In case of AC DC
(1) Run CPU after turning on power.
(2) Turn on RA2 with DC power supplied
(3) Turn on timer after DC power is stable
(4) Turn on start s/w
(5) Turn on start switch Output device runs by program through magnetic
contactor (MC) [On]
Trans
Fuse
Trans
Fuse
DC power
Fuse
Start
SW
Power
Program
Stop SW
Output module
Output module
www.behaotomasyon.com
www.behaotomasyon.com