Chapter 13 Installation and Wiring
13 16
(8) To prevent surge from lightning, use the lightning surge absorber as presented below.
(1) Isolate the grounding(E1) of lightning surge absorber from the grounding(E2) of the PLC.
(2) Select a lightning surge absorber type so that the max. voltage may not the specified
allowable voltage of the absorber.
(9) When noise may be intruded inside it, use an insulated shielding transformer or noise filter.
(10) Wiring of each input power should be twisted as short as possible and the wiring of shielding transformer
or noise filter should not be arranged via a duct.
Surge absorber to prevent
lighting 낙뢰 방지용 서지 업소
버
To Next Page
Loading...