LSIS XBF-AH04A

XGB Analog edition manual
(4) Count average value setting area (address 3)
(a) Set count average value with 0 or value of 2~6400
(b) If you set the count average value as 0, corresponding channel will not perform averaging
process and output sampled analog input value
(c) If you set 1 or more than 64001, 0 (Disable averaging) will be set forcibly.
But, U0X.01.8 (Setup error flag) will be ON.
(d) When using PUT instruction, address is as follows
bit15
bit14
bit13 bit12 bit11 bit10 bit9 bit8 bit7 bit6
bit5 bit4
bit3 bit2
bit1 bit0
Input CH0 count average value (0 or 2 ~ 64000 [times])
3
(e) This area is same as setting in “Count-Avr” of I/O parameter
(5) Channel output state setting area (address 8)
(a) Set the output state setting with the following code
Bit (Hex)
Channel output state
0000 (0)
Former value
0001 (1)
Min value
0010 (2)
Middle value
0011 (3)
Max value
10 - 38