Chapter 7. XGT Panel Function
7-13
7.4 Alarm
7.4.1 Alarm Message
When an alarm occurs, the alarm message will be displayed at the bottom of the screen.
In this case, all tags operate normally except the area that is covered by the alarm message.
When an alarm occurs, any other key input than ESC and ALM is ignored.
If the Alarm is removed after its occurrence, whether to keep the message displayed or not is available to specify in the Alarm
setting.
The displayed alarm message is a last one.
If other alarm occurs while one alarm has already occurred, the message of the latest alarm will be displayed.
7.4.2 Alarm Buzzer
If the alarm buzzer is specified, the buzzer operates when an alarm occurs.
The buzzer stops its operation if ESC or ALM key is pushed.
7.4.3 Alarm History
For the occurred alarms, their histories are saved.
There are two alarm histories, [All alarm history] and [Specific alarm history].
Refer to the section 7.1.3 Alarm History Mode for the details.
(1) All Alarm List
(1) In order it happened recently, the latest alarm is saved at 0.
(2) If alarms have occurred over 200, the earliest alarm will be erased.
(3) In case of XP10BKB/DC, the date/time of alarms occurred and removed will be saved in addition to alarm messages.
(2) Specific Alarm List
(1) Alarm history is saved for each specific alarm. (Available on XP10BKB/DC only)
(2) Displays the history of a specific alarm in order it occurs. The date and time of occurrence and removal will be only
displayed for each history.
(3) If individually specific alarms have occurred over 10, the earliest alarm will be erased to save a new specific alarm.
(4) Download the parameter from the Panel Editor to delete the Specific Alarm List.
To Next Page
Loading...
