Chapter 8. Communication Driver
8-37
8.18 LS XGK Series : Dedicated protocol
8.18.1 Communication Mode
Connection is available through LS XGK series of PLC and the Dedicated Protocol.
If connected with LS XGK series and the Dedicated Protocol, its applicable communication setting is as follows.
At this moment, the applicable communication setting of PLC and the XGT Panel to be connected between should be set
identically to each other.
Setting Contents
Setting Item
CH 1 CH 2
Remarks
Communication
Mode
RS-232C RS-422, RS-485 -
Instrument Sided
Connector
9-Pin Male connector Terminal plate or connector
-
Connection
Protocol
XGK Dedicated Protocol -
Communication
Speed
1,200/2,400/4,800/9,600/19,200/38,400/57,600/115,200bps -
Data Bit 7Bits, 8Bits -
Parity Bit None, Even Bits, Odd Bits -
Stop Bits 1 Bit, 2 Bits -
Station No. 0 ~ 31
Station No. unavailable if
identical to XGT Panel
8.18.2 Connection Available Device
The range of the connection available device with the Dedicated Protocol used is as specified in 8.2.2 ‘MASTER-K Loader Protocol’.
Connection Available Area
Device
Bit Word Long
Remarks
P Area P00000 - P2047F P0000 - P2047 P0000 - P2046
ex) PD0000F :
P0’s bit 15
M Area M00000 - M2047F M0000 - M2047 M0000 - M2046 -
K Area
K00000 - K2047F K0000 - K2047 K0000 - K2046 -
F Area F00000 - F2047F F0000 - F2047 F0000 - F2046 Read dedicated
T Area T0000 - T2047 T0000 - T2047 T0000 - T2046 -
C Area C0000 - C2047 C0000 - C2047 C0000 - C2046 -
U Area U00.00.0 - U7F.31.F U00.00 - U7F.31
U00.00 - U7F.30
-
S Area S00.00 - S127.99 -
-
Bits Read
unavailable
L Area L000000 - L11263F L00000 - L11263
L00000 - L11262
-
N Area - N00000 - N21503
N00000 - N21502
-
D Area D00000.0 - D32767.F D00000 - D32767
D00000 - D32766
-
ZR Area - ZR00000 - ZR65535
ZR00000 - ZR65534
-
To Next Page
Loading...
