PARTNER MAIL - Initial Programming
Modifying the Day and Night Main Menus
■
■
■
■
1.
2.
3.
4.
5.
6.
Refer to Form 5: Automated Attendant Day Greeting and Menu.
Refer to Form 6: Automated Attendant Night Greeting and Menu.
Factory Settings: Selector Codes 1 through 5 are set for Selector Code Action
5 — Direct Extension Transfer. Selector codes 6 through 9 are unassigned.
This enables callers to enter extensions 10 through 57 directly after reaching
the Automated Attendant service.
NOTE:
Submenus and announcements must be created before the Main
Menus. Refer to the preceding instructions for “Creating Submenus”
and “Creating Announcements.”
To eliminate background noise, speak into the handset to record menu
prompts.
Access the Administration Main Menu as described in an earlier section.
The system plays the system programming options.
Press [
3
] for Automated Attendant
Choose:
—
Press [
1
] to program the Day Main Menu.
—
Press [
2
] to program the Night Main Menu.
Press [
6
] to modify the Main Menu.
Enter the Selector Code [
1
] through [
9
].
The system plays the current Selector Code Action for the Selector Code.
Press [ 9
] to confirm that you are modifying this Selector Code.
4-22 Program Automated Attendant Menus
To Next Page
Loading...
Need help?
General