LulzBot TAZ Workhorse - Travel Tab Settings

2.13. TRAVEL TAB SETTINGS
Number of Slower Layers
This setting will slow down additional layers past the initial layer speed
settings. The speeds will slowly increase over X number of layers, moving
from initial layer speeds to standard speeds.
Equalize Filament Flow
This setting will automatically speed up or slow down your print, to
maintain an equal ow volume. After initiating this option, you will be
able to dene the maximum speed at which your printer will move. If you
choose to use this ability, it is best to nd your maximum extrusion speed
for your specic lament and temperature.
Enable Acceleration and Jerk Control
Enabling Jerk and Acceleration control will allow you to specify dierent
accelerations and jerks depending upon specic parts of your print. Initially
all settings are set to your rmware defaults, and can be adjusted higher
for faster prints or lower for slower more accurate prints.
2.13 Travel Tab Settings
The travel tab setting will dene how your printer moves when not
extruding material onto your part
Combing Mode
Combing mode will control where your hot end moves when not extruding
material. There are four options that will slightly dier in how the printer
handles this process:
• Off will allow your hot end to take the shortest possible route when
developing a tool path.
• All will prevent your hot end from moving over previously printed
areas while traveling. This can help reduce visible oozing, allowing a
cleaner outer surface of your object. This will increase print time, as
55