LulzBot TAZ Workhorse - Infill Tab Settings

Cura LulzBot Edition
• Ironing pattern will allow you to specify how your horizontal layers
are ironed. It is recommended to check layer view after selecting to
ensure the ironing pattern ts your needs.
• Iron line spacing determines how far apart the lines are when
“ironing” your top layers.
• Ironing flow allows you to extrude slightly while ironing. This can
help ll any gaps in the top layer, but can be detrimental if set too
high.
• Ironing inset will allow you to determine a distance to avoid from
the outer edge of your object. This prevents material from being
pushed over the wall of your object.
• Ironing speed allows you to specify a speed at which the ironing
will occur.
2.10 Infill Tab Settings
The inll section in custom settings controls how the inner portions of your
model are printed. Here you will nd details on how each setting will aect
your overall print.
Infill Extruder
On a dual extruder printer, you can specify which hot end will be used for
inll of the object. If you select “not overridden” it will print the inll for
each object with the assigned extruder
Infill Density
You can dene an inll percentage, and Cura will automatically place inll
at the proper spacing to meet this percentage. Cura will follow whatever
pattern you have selected on inll pattern. Alternatively, you can specify
a line distance and it will ignore the inll percentage setting.
44