Cura LulzBot Edition
the travel path will need extra moves to avoid those sections of your
print.
• No Skin will prevent the hot end from moving over nal surface areas,
providing cleaner top surfaces.
• Within Infill will keep the travel paths of the tool head within
inll areas whenever possible. This will allow for cleaner walls and
top surfaces, at the expense of additional print time.
Avoid Printed Parts When Traveling
Avoid printed parts when traveling will add additional travel moves to
prevent your nozzle from going over a previously printed part. This can
be helpful when printing multiple objects on the same plate to prevent any
collisions with previous parts when traveling.
Layer Start
The layer start settings allow you to specify a point on the x/y coordinate
plane which forces the tool head to travel to that point before starting a
new layer. In order to help reduce print time, it is best to match this setting
to the new layer start points.
Z Hop
The Z hop settings are helpful for improving quality across all model
les. When activated, it will raise your extruder by X mm when not
extruding. This gives clearance when moving over printed objects which
reduces stringing and blobs on the outer portion of your prints caused by
travel moves. Additionally, you can add Z hop when switching between
extruders during dual extrusion.
2.14 Cooling Settings Tab
The cooling settings tab will allow you to change how your material is kept
crisp and clean. If you are getting droopy results, you are printing too hot
56
To Next Page
Loading...
