LulzBot TAZ Workhorse - Page 70

Cura LulzBot Edition
Minimum Polygon Circumference
Minimum polygon circumference denes the smallest polygon that will
attempt to be sliced. Any polygons that have a smaller circumference
than set will be ignored.
Maximum Resolution
Maximum resolution denes the minimum length of a line segment gener-
ated while slicing. Smaller numbers provide greater resolution, but will
take additional time to process gcode.
Maximum Travel Resolution
Maximum travel resolution will determine the minimum travel line segment.
In general this setting should be just underneath your nozzle size.
Break Up Support In Chunks
Break up support in chunks will allow you to skip lines in the Zig Zag
support pattern. This makes support easier to remove, but may not be as
stable. After activating this option support chunk size will dene how
often you skip a layer in millimeters and support chunk line count will
allow you to dene every X layer it will happen.
Enable Draft Shield
Enable draft shield will create a single wall (think “shield”) around your
object. The intent is to maintain heat from the printed object to enable
more uniform cooling, preventing warping. After being activated you can
dene how far away from your object the shield is, and how high it extends
around your object.
Make Overhang Printable
Make overhang printable will change the geometry of the model itself. This
will change any overhang angles to your set amount. It is recommended to
change your model geometry in the CAD program of your choice opposed
to this option.
70